ファームウェア 1.11 でハックキット：ハックキットで起動

HDD の交換（LS-WSGL, LS-QL 以外）

起動

	:
	:
---- in hackkit linuxrc ---
grep: /var/tmp/devlink: No such file or directory
-- rebuild mdadm.conf for BOOT, ROOTFS --
mdadm: cannot open /dev/disk2_1: No such device or address
mdadm: cannot open /dev/disk2_2: No such device or address
mdadm: cannot open /dev/disk2_5: No such device or address
md: md10 stopped.
mdadm: cannot open device /dev/disk2_1: No such device or address
mdadm: /dev/disk2_1 has wrong uuid.
mdadm: /dev/disk1_1 has wrong uuid.
mdadm: cannot open device /dev/disk2_2: No such device or address
mdadm: /dev/disk2_2 has wrong uuid.
mdadm: /dev/disk1_2 has wrong uuid.
mdadm: cannot open device /dev/disk2_5: No such device or address
mdadm: /dev/disk2_5 has wrong uuid.
md: bind<sda5>
raid1: raid set md10 active with 1 out of 4 mirrors
mdadm: /dev/md10md: md1 stopped.
 has been started with 1 drive (out of 4).
mdadm: /dev/disk1_1 has wrong uuid.
md: bind<sda2>
raid1: raid set md1 active with 1 out of 4 mirrors
mdadm: /dev/md1 md: md0 stopped.
has been started with 1 drive (out of 4).
md: bind<sda1>
raid1: raid set md0 active with 1 out of 4 mirrors
mdadm: /dev/md0 has been started with 1 drive (out of 4).
-- setup max error counts --
/sys/block/md0/md/maxerr_cnt is setted to -1
/sys/block/md1/md/maxerr_cnt is setted to -1
/sys/block/md10/md/maxerr_cnt is setted to -1
umount: cannot open /proc/mounts
Filesystem "md1": Disabling barriers, not supported by the underlying device
XFS mounting filesystem md1
VFS: Mounted root (xfs filesystem).
Trying to move old root to /initrd ... okay
Freeing init memory: 120K
INIT: version 2.86 booting
Setting the system clock.
Activating swap...Adding 1003896k swap on /dev/md10.  Priority:-1 extents:1 across:1003896k
done.
Filesystem "md1": Disabling barriers, not supported by the underlying device
Setting the system clock.
Cleaning up ifupdown....
Loading kernel modules...done.
Checking file systems...fsck 1.41.3 (12-Oct-2008)
done.
Setting kernel variables (/etc/sysctl.conf)...done.
Mounting local filesystems...kjournald starting.  Commit interval 5 seconds
EXT3 FS on md0, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
XFS mounting filesystem sda6
done.
Activating swapfile swap...done.
Setting up networking....
Configuring network interfaces...eth reg(9) val=0x0300
eth0: link down
done.
INIT: Entering runlevel: 2
Starting enhanced syslogd: rsyslogd.
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
ehci_marvell ehci_marvell.4523: Marvell Orion EHCI
ehci_marvell ehci_marvell.4523: new USB bus registered, assigned bus number 1
ehci_marvell ehci_marvell.4523: irq 17, io base 0xf1050100
ehci_marvell ehci_marvell.4523: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
eth0: link up, full duplex, speed 1 Gbps
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
ehci_marvell ehci_marvell.167817: Marvell Orion EHCI
ehci_marvell ehci_marvell.167817: new USB bus registered, assigned bus number 2
ehci_marvell ehci_marvell.167817: irq 12, io base 0xf10a0100
ehci_marvell ehci_marvell.167817: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
USB Universal Host Controller Interface driver v3.0
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Starting internet superserver: inetd.
Starting periodic command scheduler: crond.

Debian GNU/Linux 5.0 qube ttyS0

qube login:

LS-QL バッファローダイレクト 楽天市場 amazon livedoorデパート Sofmap バリューモア Yahoo!ショッピングトップ ムラウチドットコム