新型 LS-GL（４）玄箱のサブボード＋HDD で起動

LS-GL と玄箱/Pro とに互換性がなければ、 初回の起動で煙を吹くことになる（汗）

電源 ON

Orion1   CPU =  Low

=== BUFFALO LS-GL U-Boot. ===
 ** LOADER **
 ** BUFFALO BOARD: BUFFALO_BOARD_LS_GL LE (CFG_ENV_ADDR=fffff000)


U-Boot 1.1.1 (Apr 18 2007 - 18:35:44) Marvell version: 1.12.1 - TINY

DRAM CS[0] base 0x00000000   size 128MB
DRAM Total size 128MB
[256kB@fffc0000] [0kB@f8000000] ## Unknown FLASH at f8000000: Size = 0x00000000 = 0 MB
Flash: 256 kB
Addresses 20M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (20M - 16M): Done

Soc: 88F5182 A2
CPU: ARM926 (Rev 0) running @ 400Mhz
Orion 1 streaming disabled
SysClock = 200Mhz , TClock = 166Mhz


USB 0: host mode
USB 1: host mode
PCI 0: PCI Express Root Complex Interface
PCI 1: Conventional PCI, speed = 33000000
Net:   egiga0 [PRIME]
Using 88E1118 phy

Marvell Serial ATA Adapter
Integrated Sata device found
  Device 0: OK
Model: ST3120026AS                              Firm: 3.18     Ser#: 3JT328G2
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 114473.4 MB = 111.7 GB (234441648 x 512)

Using device ide0, partition 1

Loading from block device ide device 0, partition 1: Name: hda1
  Type: U-Boot  File:/initrd.buffalo

ブート失敗

0 bytes read
Using device ide1, partition 1
** Bad partition 1 **
Lost all init_rd
hit any key to switch tftp boot.
Hit any key to stop autoboot:  0
Using egiga0 device
TFTP from server 192.168.11.1; our IP address is 192.168.11.150
Filename 'uImage.buffalo'.
Load address: 0x100000
Loading: T T
Retry count exceeded; starting again
Using egiga0 device
TFTP from server 192.168.11.1; our IP address is 192.168.11.150
Filename 'uImage.buffalo'.
Load address: 0x100000
Loading: T T

わかったこと

というわけで、そう簡単にはいかなかった。

LS-160GL 楽天市場 Amazon Yahoo!ショッピング ソフマップ ツクモネットショプ livedoor デパート ドスパラ