dmesg

~ # dmesg
Linux version 2.6.12.6-arm1 (root@dev-hara2) (gcc version 3.4.4 (release) (CodeSourcery ARM 2005q3-2)) #4 Fri Aug 3 10:34:52 JST 2007

CPU: ARM926EJ-Sid(wb) [41069260] revision 0 (ARMv5TEJ)
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 1, 32 byte lines, 512 sets
CPU0: D cache: 16384 bytes, associativity 1, 32 byte lines, 512 sets
Machine: Feroceon
Using UBoot passing parameters structure
Sys Clk = 166666667, Tclk = 133333333

Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 4096
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 0 pages, LIFO batch:1
  HighMem zone: 0 pages, LIFO batch:1
Built 1 zonelists
Kernel command line: console=ttyS0,115200 root=/dev/sda2 rw initrd=0x01400000,4M panic=5 BOOTVER=1.02L

PID hash table entries: 128 (order: 7, 2048 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 8MB 8MB 0MB 0MB = 16MB total

Memory: 9416KB available (2186K code, 361K data, 96K init)
Calibrating delay loop... 219.54 BogoMIPS (lpj=1097728)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
checking if image is initramfs...it isn't (no cpio magic); looks like an initrd
Freeing initrd memory: 4096K
NET: Registered protocol family 16

CPU Interface
-------------
SDRAM_CS0 ....base 00000000, size  16MB
SDRAM_CS1 ....base 01000000, size  16MB
PEX0_MEM ....base e0000000, size 128MB
PEX0_IO ....base f2000000, size   1MB
INTER_REGS ....base f1000000, size   1MB
NFLASH_CS ....base f9000000, size   2MB
MFLASH_CS ....base f8100000, size 256KB
SPI_CS ....base fa000000, size   8MB
BOOT_ROM_CS ....base fc000000, size   1MB
DEV_BOOTCS ....base fc000000, size   1MB
CRYPT_ENG ....base f0000000, size  64KB
 mv_mtd_initialize Error : Unknown board

  Marvell Development Board (LSP Version 2.1.10_TG)-- RD-88F6082-DAS-PLUS  Soc: MV88F6082 Rev 1

 Detected Tclk 133333333 and SysClk 166666667
Marvell USB EHCI Gadget controller #0: c02efb00
mvPexBarSet: ERR. Target 2 window invalid
mvPexInit: ERR. mvPexBarSet 2 failed
pci_init:Error calling mvPciIfInit for pciIf 0
IO Request resource failed - Pci If 0
PCI: bus0: Fast back to back transfers enabled

SCSI subsystem initialized
Fast Floating Point Emulator V0.9 (c) Peter Teichmann.

inotify device minor=63
SGI XFS with no debug enabled
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
ttyS0 at MMIO 0x0 (irq = 3) is a 16550A

io scheduler noop registered
RAMDISK driver initialized: 3 RAM disks of 5120K size 1024 blocksize

loop: loaded (max 8 devices)
Marvell Gigabit Ethernet Driver 'egiga':
  o Ethernet descriptors in DRAM
  o DRAM SW cache-coherency
  o Checksum offload enabled
  o Marvell ethtool proc enabled
  o Rx desc: 64
  o Tx desc: 128
  o Loading network interface 'eth0' 'eth1'

Intergrated Sata device found
scsi0 : Marvell SCSI to SATA adapter
  Vendor: SAMSUNG   Model: HD501LJ           Rev: CR10
  Type:   Direct-Access                      ANSI SCSI revision: 03
SCSI device sda: 976773168 512-byte hdwr sectors (500108 MB)
SCSI device sda: drive cache: write back
SCSI device sda: 976773168 512-byte hdwr sectors (500108 MB)
SCSI device sda: drive cache: write back
 sda: sda1 sda2 sda4 < sda5 sda6 >
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0,  type 0
physmap flash device: 40000 at f8100000
CFI: Found no phys_mapped_flash device at location zero
JEDEC: Found no phys_mapped_flash device at location zero
Marvell Flash Detected @ 0xf8100000, 256KB Main region (64sec x 4KB), 2KB Information region

mice: PS/2 mouse device common for all mice

mvGppValueSet: Err. An attempt to set output value to GPP 3 in input mode.
Buffalo Platform Linux Driver(Light) (C) BUFFALO INC. Ver.0.01 installed.
Kernel message queue controll (C) BUFFALO INC. Ver.1.00 installed.
Kernel event for procfs (C) BUFFALO INC. Ver.1.00 installed.
Buffalo CPU Inerupts Driver (C) BUFFALO INC. Ver.0.01 alpha1 installed.
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: Compressed image found at block 0
EXT2-fs warning: checktime reached, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
kjournald starting.  Commit interval 5 seconds
EXT3-fs warning: checktime reached, running e2fsck is recommended
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3-fs warning: mounting fs with errors, running e2fsck is recommended
EXT3 FS on sda2, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3-fs warning: mounting fs with errors, running e2fsck is recommended
EXT3 FS on sda2, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem).
Trying to move old root to /initrd ... okay
Freeing init memory: 96K
Adding 136512k swap on /dev/disk1_5.  Priority:-1 extents:1
kjournald starting.  Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
XFS mounting filesystem sda6
Ending clean XFS mount for filesystem: sda6
eth0: link down
eth0: link up<5>, full duplex<5>, speed 1 Gbps<5>
~ #

LS-L250GL 楽天市場 Amazon Yahoo! ショッピング Sofmap TSUKUMO ネットショップ ValuMore! ムラウチドットコム uWorks パソＱ